General Discussion

This is a Peck Polymer ROG that I built using my own 1/16 balsa sticks cut from 10 lb balsa. I covered it in 3.4 gm/m^2 Jap Tissue that I ran through my inkjet printer to make the bubble pattern. I also preshrunk the tissue before printing and covering. The plane makes three laps of the gym end climbing almost to the ceiling before landing just near my feet. I wound it to 500 turns, 550 put it in the rafters. Notice the RC planes were flying clockwise. I tried CW, but the ROG just can't fight the torque from the prop.