This post is from a suggested group
Minutes from October 2, 2025 meeting, draft
29 Views
top of page
Groups Feed
View groups and posts below.
This post is from a suggested group
Agenda, Treasurer Report and lawsuit summary for IEQF Monthly Meeting 2025-11-06
14 Views
This post is from a suggested group
Welcome to our group IEQF Group! A space for us to connect and share with each other. Start by posting your thoughts, sharing media, or creating a poll.
17 Views
This post is from a suggested group
Agenda and Treasurer report for 2025-10-02 General Membership Meeting | Minutes from 2025-09-04 Meeting
20 Views
This post is from a suggested group
The lock on the field won’t lock
32 Views
This post is from a suggested group
3/4” impact driver
The tie down anchors are going to be hard to install. I welded a lug nut on the end and got part way into the ground with my 1/2” driver before it stalled out. I think a 3/4” will work.
Does anyone have one?
Here’s what the anchors for the canopy look like:
10 Views
parksleonard717
24 sep
If noone has a 3/4 impact driver I think one can be rented at Ato Z rental, or a home depot tool rental.
This post is from a suggested group
Sept 4, 2025 meeting Agenda/Treasurer Report & previous minutes. Note: Meeting to be held 6PM at Harvester Restaurant in Spangle.
6 Views
This post is from a suggested group
Canopy suggestion
With the help of AI, I analyzed the canopy for a 60mph wind load and generated results for max rope tension and pipe buckling margins. Here is a screenshot of the recommended Home Depot hardware.
The analysis considers uplift and lateral wind loads.
22 Views
Phil Pintor
26 aug
This is the cost of a 20’ x 30’. Will have to check if a 10’ width will cover adequately.
This post is from a suggested group
Fixing my xplorer wing
Does anyone have any Carboweave CW30? I need a couple small strips 1” wide by 10” long. I’ll buy it from you.
23 Views
Phil Pintor
25 aug
Ok, since nobody had any carboweave I can spread the small tow pieces myself.
Now I’m looking to borrow a vacuum pump for bagging the wing repairs. Anyone have one?
bottom of page
There is an old lock on the chain in addition to the one we use. So there is confusion at times about which to use. (Sometime we'll have to get a portable grinder tool out there that can cut through its hardened steel). In the mean time David Duhaime said he will 'magic marker' the old lock to indicate it isn't the one to use.